46 lines
1.0 KiB
Plaintext
46 lines
1.0 KiB
Plaintext
[pi3]
|
|
kernel=u-boot-rpi3.bin
|
|
|
|
[pi02]
|
|
kernel=u-boot-rpi3.bin
|
|
|
|
[pi4]
|
|
kernel=u-boot-rpi4.bin
|
|
enable_gic=1
|
|
armstub=armstub8-gic.bin
|
|
|
|
# Otherwise the resolution will be weird in most cases, compared to
|
|
# what the pi3 firmware does by default.
|
|
disable_overscan=1
|
|
|
|
# Supported in newer board revisions
|
|
arm_boost=1
|
|
|
|
[cm4]
|
|
# Enable host mode on the 2711 built-in XHCI USB controller.
|
|
# This line should be removed if the legacy DWC2 controller is required
|
|
# (e.g. for USB device mode) or if USB support is not required.
|
|
otg_mode=1
|
|
|
|
[all]
|
|
# Boot in 64-bit mode.
|
|
arm_64bit=1
|
|
|
|
# U-Boot needs this to work, regardless of whether UART is actually used or not.
|
|
# Look in arch/arm/mach-bcm283x/Kconfig in the U-Boot tree to see if this is still
|
|
# a requirement in the future.
|
|
enable_uart=1
|
|
|
|
# Prevent the firmware from smashing the framebuffer setup done by the mainline kernel
|
|
# when attempting to show low-voltage or overtemperature warnings.
|
|
avoid_warnings=1
|
|
|
|
gpu_mem=16
|
|
arm_freq=1800
|
|
|
|
# disable bluetooth
|
|
dtoverlay=disable-bt
|
|
|
|
# disable wifi
|
|
dtoverlay=disable-wifi
|