Add an example config.txt
This commit is contained in:
parent
ee613016bd
commit
bded558d89
|
@ -0,0 +1,39 @@
|
|||
[pi3]
|
||||
kernel=u-boot-rpi3.bin
|
||||
|
||||
[pi02]
|
||||
kernel=u-boot-rpi3.bin
|
||||
|
||||
[pi4]
|
||||
kernel=u-boot-rpi4.bin
|
||||
enable_gic=1
|
||||
armstub=armstub8-gic.bin
|
||||
|
||||
# Otherwise the resolution will be weird in most cases, compared to
|
||||
# what the pi3 firmware does by default.
|
||||
disable_overscan=1
|
||||
|
||||
# Supported in newer board revisions
|
||||
arm_boost=1
|
||||
|
||||
[cm4]
|
||||
# Enable host mode on the 2711 built-in XHCI USB controller.
|
||||
# This line should be removed if the legacy DWC2 controller is required
|
||||
# (e.g. for USB device mode) or if USB support is not required.
|
||||
otg_mode=1
|
||||
|
||||
[all]
|
||||
# Boot in 64-bit mode.
|
||||
arm_64bit=1
|
||||
|
||||
# U-Boot needs this to work, regardless of whether UART is actually used or not.
|
||||
# Look in arch/arm/mach-bcm283x/Kconfig in the U-Boot tree to see if this is still
|
||||
# a requirement in the future.
|
||||
enable_uart=1
|
||||
|
||||
# Prevent the firmware from smashing the framebuffer setup done by the mainline kernel
|
||||
# when attempting to show low-voltage or overtemperature warnings.
|
||||
avoid_warnings=1
|
||||
|
||||
gpu_mem=16
|
||||
arm_freq=1800
|
Loading…
Reference in New Issue